Epoxy Pipe Lining in Pflugerville, TX

When should you call about epoxy pipe lining?

• Pinhole leaks
• Corrosion inside the pipes
• Pipes that are otherwise sound

What should you do right now?

1. Shut off the main water valve. It is in the meter box near the street, or where the main line enters your garage or an outside wall. Turn it clockwise until it stops.
2. Warm floor? Close the cold-water inlet on top of the water heater.
3. Water near outlets? Stay away. Switch off the breaker only if you are on dry ground.
4. Smell gas? Leave and call your gas utility or 911 from outside.

What will the local provider do?

1. Check the pipes with a camera
2. Dry and clean the pipe inside
3. Coat it with epoxy
4. Let it cure and test

Start with the Pflugerville slab leak homepage if you are not sure what you need.

What causes the problems epoxy pipe lining finds?

Epoxy lining seals the inside of a pipe. It suits certain types of damage better than others.

• Pinhole leaks from corrosion
• Thin pipe walls in otherwise sound pipe
• Scale buildup that narrows pipe
• Pipes that are hard to reach without major demolition

Which warning signs matter most?

What should you expect?

The pipe is dried and cleaned from the inside, then coated with epoxy that hardens to form a new inner wall. The line is left to cure before water is turned back on.

When is this the right choice?

Lining can be a good fit when pipes are corroding from the inside but are still structurally sound. It is less suited to large breaks, collapsed pipe or lines damaged by severe slab movement. A camera check before the work helps the provider confirm the pipe is a good candidate.

How can you prevent it?

• Ask for a camera check before lining
• Ask what product is used and how long it has been in use
• Keep records of which lines were lined
• Recheck water pressure after the work

What is epoxy pipe lining?

Epoxy pipe lining repairs pipes from the inside. The pipe is dried and cleaned, then coated with epoxy that cures into a new inner layer. This seals small leaks and pinholes and protects the pipe from further wear. Because the work is done through the pipe, the slab and floors do not need to be opened.

Lining is used for both water supply lines and drain lines, though the methods differ. For drain lines, a cured-in-place liner is often used to form a new pipe within the old one.

How does lining work?

1. The provider inspects the pipe, often with a camera for drains.
2. The line is drained and dried with heated air.
3. The inside of the pipe is cleaned of scale and corrosion.
4. Epoxy is blown or pulled through the pipe to coat the walls.
5. The epoxy cures to form a new lining.
6. The line is tested and returned to service.

When is lining a good fit?

What are the benefits and trade-offs?

• No digging or cutting through floors
• Less disruption inside the home
• Protects the full length of the lined pipe
• Can be faster than tunneling or rerouting

Lining slightly reduces the inside diameter of the pipe. It also depends on good surface preparation to bond well. Ask the provider about the product used, how long it has been in use, and what guarantee comes with it.

What should you ask before lining?

• Is my pipe a good candidate for lining?
• What product will you use?
• How will you prepare the pipe?
• How long will water be off?
• How will you confirm the lining is complete?
• What guarantee comes with the work?

How long does lining take?

Many lining jobs are done in a day or two, depending on the number of lines and how much cleaning the pipe needs. Water to the lined lines is off during the work. Curing time depends on the product and conditions. Ask the provider how long water will be off and when you can use the lined lines again.

How does lining compare with other repairs?

Lining avoids cutting floors and digging, which makes it attractive in finished homes. It works best on pipe that is still structurally sound. If the pipe is badly corroded, cracked through or collapsed, a repair, reroute or repipe is the better choice. A camera inspection and pressure test before lining help show which group your pipe falls into.

Ask the provider to explain why lining fits your pipe, and what they would suggest if it does not.

What should you check after lining?

• Confirm the line was tested after the lining cured
• Watch the meter with all fixtures off for a few days
• Keep the product name, report and guarantee in your records
• Ask for camera footage of drain lines after lining

What affects the cost of lining?

• Number and length of lines lined
• Pipe diameter and number of bends
• How much cleaning the pipe needs
• Product chosen
• Access points needed at each end

Ask for a written quote and compare it with the cost of repair or reroute for the same line, including flooring or drywall work.

Is lining a permanent fix?

Lining creates a new inner surface for the pipe, and many products are designed to last for years. How long it lasts depends on the product, the pipe condition and how well the pipe was prepared. Ask for the expected life and the guarantee in writing.

Where in Pflugerville can you get epoxy pipe lining?

• Slab leak detection in Blackhawk 78660
• Slab leak detection in Windermere 78660
• Slab leak detection in Falcon Pointe 78660
• Slab leak detection in Villages of Hidden Lake 78660
• Slab leak detection in Highland Park 78660
• Slab leak detection in Heatherwilde 78660
• Slab leak detection in Avalon 78660
• Slab leak detection in Sorento 78660
• Slab leak detection in Carmel 78660
• Slab leak detection in Springbrook 78660
• Slab leak detection in Commons at Rowe Lane 78660
• Slab leak detection in Northtown Park 78660
• Slab leak detection in Brookfield 78660
• Slab leak detection in Cambridge Heights 78664
• Slab leak detection in Park at Wellspoint 78664
• Slab leak detection in Verona 78660
• Slab leak detection in Bohls Place 78660

Related services

• Slab Leak Repair
• Pipe Rerouting
• Whole House Repipe
• Tunneling Under Slab
• Direct Access Repair

Epoxy Pipe Lining questions